TM 9-2350-238-20-1
2-119. MAINTENANCE OF LOW COOLANT WARNING LIGHT TO BULKHEAD
DISCONNECT BRANCHED WIRING HARNESS (CONT).
3
Disconnect shell connector (2) from
driver’s compartment dome light.
Failure to remove or disconnect
batteries before removing or installing
4
Disconnect shell connector (3) from line
any electrical wiring harness or lead
disconnect to circuit breaker.
may result in injury or damaged
equipment.
5
Disconnect two shell connectors (4) from
line disconnects to aeration detector.
1
Wiring harnesses and leads are secured to
the hull and components with loop clamps,
6
Remove low coolant warning light to
straps, clips, ground screws, etc. Remove
bulkhead disconnect branched wiring
only the hardware which secures the
harness (5) from hull through driver’s
wiring harness or lead being removed.
compartment.
2
Disconnect plug connector (1) from low
engine coolant warning indicator light.
For disassembly of wiring harness plug connector, refer to general maintenance, page 2-371.
2-732