TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 732 of 1364

TM 9-2350-238-20-1

2-109. MAINTENANCE OF FUEL PURGE-AND-PRIME SWITCH TO FILTER PRIMING PUMP

ELECTRICAL LEAD (ENGINE MODEL 7083-7395) (CONT).

1

2

3

4

Failure to remove or disconnect batteries before removing or installing any electrical

wiring harness or lead may result in injury or damaged equipment.

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc.

Remove only the hardware which secures the wiring harness or lead

being removed.

Disconnect shell connector (1) from prime switch.

Disconnect shell connector (2) from pump.

Remove fuel purge-and-prime switch to solenoid electrical lead (3) from hull through driver’s

compartment.

1

Inspect for broken, damaged, or missing parts.

2

If damaged or missing, replace marker bands.

3

For repair of shell connectors, refer to general

4

Electrical wire is a manufactured item, refer to

Etch or stamp lead number on new band.

maintenance, page 2-371.

appendix D.

5

Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).

2-706