TM-9-2350-238-20-1

HULL AND RELATED COMPONENTS RECOVERY VEHICLE, FULL TRACKED: LIGHT, ARMORED, M578

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL

MAY 1994

TM-9-2350-238-20-1 - Page 723 of 1364

TM 9-2350-238-20-1

3

Tag and disconnect shell connector (2) from circuit breaker.

4

Tag and disconnect shell connector (3) from electrical horn.

5

Tag and disconnect shell connector (4) from line connection disconnect.

6

Remove horn to warning relay wiring harness (5) from hull through driver's compartment.

DISASSEMBLY

For disassembly of wiring harness plug connector, refer to general maintenance, page 2-371.

1

Inspect for broken, damaged, or missing parts.

2

If damaged or missing, replace marker bands. Etch or stamp lead number on new band.

3

For repair of shell connectors, refer to general maintenance, page 2-371.

4

Electrical wire is a manufactured item, refer to appendix D.

5

Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).

For reassembly of wiring harness plug connector, refer to general maintenance, page 2-371.

1

Install horn to warning relay wiring harness (5) to hull through driver's compartment.

2

Untag and connect shell connector (4) to line connection

3

Untag and connect shell connector (3) to electrical horn.

4

Untag and connect shell connector (2) to circuit breaker.

5

Untag and connect plug connector (1) to warning relay.

disconnect.

6

Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

2-697