TM-9-2350-256-10

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

OPERATOR'S MANUAL

OCTOBER 2014

TM-9-2350-256-10 - Page 545 of 796

Table 1.

Operator Preventive Maintenance Checks and Services (PMCS) – After - Continued.

ITEM

NO.

INTERVAL

ITEM TO BE

CHECKED OR

SERVICED

PROCEDURE

EQUIPMENT

NOT READY/

AVAILABLE IF:

Figure 5.

Fill Cap and Oil Gauge Rod.

WARNING

Do not operate with transmission oil level

above the FULL mark on oil gauge rod. Smoke

and fire may occur in vehicle exhaust system.

Failure to comply may result in personnel

death, injury, and/or damage to equipment.

NOTE

If oil level is between ADD and FULL mark,

go to Step 9. If oil level needs to be

adjusted, perform Step 8a or 8b.

8. Adjust oil level.

NOTE

1/2 in. on oil gauge rod equals approximately

one gallon of oil.

a. If the oil is below the ADD mark. Add oil to bring

the oil level between the ADD and FULL mark. Refer to

Lubrication Instructions (WP 0101) for proper oil and

filling instructions. Start main engine (WP 0010), let run

approximately five minutes. Move transmission shift

selector lever through all ranges (WP 0012). Shut

down main engine (WP 0017), wait three to five

minutes, and repeat Steps 5, 6, and 7.

TM 9-2350-256-10

0098

0098-7