TM-9-2350-256-10
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
OPERATOR'S MANUAL
OCTOBER 2014
TM-9-2350-256-10 - Page 546 of 796
Table 1.
Operator Preventive Maintenance Checks and Services (PMCS) – After - Continued.
ITEM
NO.
INTERVAL
ITEM TO BE
CHECKED OR
SERVICED
PROCEDURE
EQUIPMENT
NOT READY/
AVAILABLE IF:
NOTE
Transmission oil sampling valve may be
used to remove excess oil from
transmission.
b. If the oil level is above FULL mark on oil gauge
rod, start main engine (WP 0010) and run for five
minutes. Move transmission shift selector lever through
all ranges (WP 0012). Shut down main engine
(WP 0017), wait three to five minutes, and repeat
Steps 5, 6, and 7. If oil level remains above FULL
mark; adjust oil level between ADD mark and FULL
mark by removing excess oil.
9. Install oil gauge rod into transmission oil filler tube.
Close access doors, engine deck exhaust grille, and
exhaust deflector (WP 0029).
10
AFTER
Engine
Compartment
1. Open engine deck access doors (WP 0030), and
remove front deck grilles (WP 0030).
2. Check for fluid leaks.
Any fuel leak or Class III
oil leak.
3. Check for damaged, distorted, or broken hoses;
tubes or line connectors, assemblies (nuts, adapters),
reduction fitting, and couplers.
Any damaged or distorted
hoses, tubes, lines, or
connector assemblies.
11
AFTER
Vehicle Exterior
Walk around vehicle. Check for fluid leakage, missing
items, tampering, or damage to equipment.
Any fuel leaks.
Any Class III oil or
hydraulic fluid leak found.
Vehicle has damage or is
missing items that would
make operation
hazardous.
12
AFTER
External Fire
Extinguisher
Handles
Check for missing or damaged lead seals, lockwires, or
handles.
Missing or damage lead
seals, lockwires, or
handles.
Figure 6.
External Fire Extinguisher Handles.
TM 9-2350-256-10
0098
0098-8
Back to Top
