TM-9-2350-256-10

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

OPERATOR'S MANUAL

OCTOBER 2014

TM-9-2350-256-10 - Page 536 of 796

Table 1.

Operator Preventive Maintenance Checks and Services (PMCS) – During - Continued.

ITEM

NO.

INTERVAL

ITEM TO BE

CHECKED OR

SERVICED

PROCEDURE

EQUIPMENT

NOT READY/

AVAILABLE IF:

6. Remove oil gauge rod, and verify oil level on

ENG IDLING RANGE side of oil gauge rod is within

ENG IDLING RANGE marks.

WARNING

Hot engine surfaces can ignite engine oil.

Clean oil from around oil filler tube area with

wiping rags after filling. Ensure engine oil

filler tube cap is tight and engine oil fill

access door is closed and latched. Failure

to comply may result in personnel death,

injury, and/or damage to equipment.

7. If oil level is below hash marks on ENG IDLING

RANGE side of oil gauge rod, add oil and recheck. To

add proper grade oil:

a. Pull up on engine oil filler tube cap handle and

open engine oil filler tube.

b. Insert offset funnel in oil filler tube.

c. Add oil as required using offset funnel. Refer to

Lubrication Instructions (WP 0101).

Figure 6.

Filling Procedure.

8. Close oil filler tube cap and all access doors.

TM 9-2350-256-10

0097

0097-6