TM-9-2350-256-10

RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1

OPERATOR'S MANUAL

OCTOBER 2014

TM-9-2350-256-10 - Page 662 of 796

REMOVAL - Continued

WARNING

Always release track tension before performing maintenance on track or track adjusting

link. Failure to comply may result in personnel death or injury.

4.

Release track tension (new configuration) (WP 0110) using the following steps:

a.

Clean shaft (Figure 3, Item 4) of track adjusting link (Figure 3, Item 3) using a wire brush. Wipe shaft

clean with wiping rag, and apply coat of grease (GAA) to shaft.

WARNING

Grease will be under pressure. Personnel must wear goggles. Failure to comply may

result in personnel injury.

b.

Press in and hold plunger (Figure 3, Item 1) on grease relief valve (Figure 3, Item 2) to allow grease to

flow out of track adjusting link (Figure 3, Item 3).

c.

Catch grease with clean wiping rag.

d.

Release plunger (Figure 3, Item 1) when grease stops flowing out of track adjusting link

(Figure 3, Item 3).

e.

Wipe up grease with wiping rags.

Figure 3.

Track Adjusting Link (Release Track Tension – New Configuration).

TM 9-2350-256-10

0112

0112-4