TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 530 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR FLUID PRESSURE FILTER REPLACEMENT (Sheet 6 of 7)

5.

Using socket, install two capscrews, new

lockwashers and fiat washers (E).

6.

(2A engine).

Install capscrew, new lockwasher,

and flat washer (G) onto fuel-water separator filter

(H).

7.

(2D engine).

Position clamp (F) around sensor

wires (C) and (D) and, using socket, install

capscrew, new lockwasher, flat washer (G), and

clamp (F) onto fuel-water separator filter (H).

8.

Using socket, tighten capscrew (B).

9.

Using 9/16 inch wrench, install condensate drain

line (J) to elbow (K).

10.

Remove plastic barrier material and tape from

opening of fuel inlet line (L) and elbow (M).

11.

Using 7/8 inch wrench, install fuel line (L) to elbow

(M).

12.

Remove plastic barrier material and tape from

openings of fuel outlet line (N) and elbow (P).

13.

Using 7/8 inch wrench, install outlet line (N) to

elbow (P).

Go on to Sheet 7

TA148336

7-261