TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 525 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR FLUID PRESSURE FILTER REPLACEMENT (Sheet 1 of 7)

PROCEDURE INDEX

PROCEDURE

PAGE

Removal

7-257

Installation

7-260

Test

7-262

TOOLS:

1/2 in. socket with 1/2 in. drive

5 in. extension with 1/2 in. drive

Ratchet with 1/2 in. drive

7/16 in. combination box and open end wrench

7/8 in. combination box and open end wrench

9/16 in. combination box and open end wrench

Hammer

1/8 in. drive punch

SPECIAL TOOLS:

Ground hop kit (Item 30, Chapter 3, Section I)

SUPPLIES:

Drip pan

Rags (Item 65, Appendix D)

Masking tape (Item 57, Appendix D)

Plastic barrier material (Item 41, Appendix D)

Tags

Lockwasher (MS35338-45) (4 required)

REFERENCE:

TM 9-2350-260-10

PRELIMINARY PROCEDURE:

Remove powerplant (page 5-1)

NOTE

This procedure applies to fuel-water

separator filters on 2A and 2D

engines.

Where there are differences

in procedure, they are noted.

The 2D

engine is used to illustrate the

procedures.

Go on to Sheet 2

TA148331

7-256