TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 528 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR FLUID PRESSURE FILTER REPLACEMENT (Sheet 4 of 7)

12.

Using 7/16 inch wrench, turn bleed cap (K)

counterclockwise until loose.

Let fuel-water filter

drain.

13.

Using

socket,

remove

three

capscrews,

lockwashers, and flat washers (L).

Throw

lockwashers away.

14.

(2D engine).

Remove clamp (M) from filter (C).

NOTE

It may be necessary to tap sensor

just

above

threaded

portion

of

adapter with 1/8 inch punch and

hammer.

15.

Using socket, loosen capscrew (N) to provide

movement of fuel-water separator filter (C).

NOTE

Go to step 20 if you have a 2A

engine.

16.

Using 9/16 inch wrench, remove upper sensor (P)

from fuel-water separator filter (C).

17.

Tag upper sensor (P) to make sure of correct

installation.

18.

Using 9/16 inch wrench, remove lower sensor (Q)

from fuel-water separator filter (C).

19.

Tag lower sensor (Q) to make sure of correct

installation.

Go on to Sheet 5

TA148334

7-259