TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 518 of 772
TM 9-2350-260-20-1-2
FUEL-WATER SEPARATOR OPERATIONAL TESTS (2D ENGINE) (Sheet 5 of 11)
7.
Using adjustable wrench, loosen pipe plug in
upper sensor hole enough to allow fuel to leak.
8.
Check to see i fuel leaks from upper sensor hole
(M).
9.
If fuel does not leak from upper sensor hole (M),
remove pipe plug from upper sensor hole (M) and
go on to step 10.
If fuel does leak from upper
sensor hole (M), use adjustable wrench to tighten
pipe plug in upper sensor hole (M) and go to step
14.
CAUTION
Be very careful not to disturb center
filter element.
Center filter element
must be replaced if disturbed in any
way.
10.
Using 7/16 inch wrench, remove eight screws,
lockwashers, and flat washers (N) securing cover
to separator (P).
Remove cover (Q) from
separator (P).
11.
Add fuel to fuel-water separator (P) until fuel leaks
from upper sensor hole (M).
12.
Using adjustable wrench, install pipe plug into
upper sensor hole (M).
13.
Place cover (Q) in position and, using 7/16 inch
wrench, install eight screws, lockwashers, and fiat
washers (N).
14.
Hold tips of upper (H) and lower (J) sensor probes
in water in metal container (E).
NOTE
Remove both upper (H) and lower (J)
sensor probes from water in metal
container (E) as soon as fluid begins
draining from drain tube (B).
15.
Listen for solenoid drain valve (R) to click and
watch for fluid to begin draining from solenoid
drain valve drain tube (B).
16.
If fluid does not begin draining, refer to
troubleshooting procedures (page 4-256).
17.
If fluid does begin draining, go on to 15-second
drain test on next page.
Go on to Sheet 6
TA148324
7-249
Back to Top
