TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 517 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR OPERATIONAL TESTS (2D ENGINE) (Sheet 4 of 11)

AUTOMATIC DRAIN TEST:

1.

Place metal container (A) under solenoid drain

valve drain tube (B).

2.

Using pliers, disconnect engine electrical harness

connector (C) from fuel-water separator control

box (D) by turning counterclockwise.

3.

Fill metal container (E) with water.

4.

Connect cable (Figure F-8, Appendix F) from

negative (-) terminal of power source (F) to metal

container (E).

5.

Connect connector (G) of cable (Figure F-7,

Appendix F) to fuel water separator control box.

WARNING

Do not let upper (H) and lower (J) sensor probes come in contact with each other

or with bottom or side of metal container (E).

When moving sensor probes, do so

by holding insulated cables (K) and (L).

Do not touch probes (H) or (J) with hands.

6.

Connect red wire of cable to positive terminal of power source (F).

7.

Connect black wire of cable to negative (-) terminal of power source (F).

Go on to Sheet 5

TA148323

7-248