TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 524 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR OPERATIONAL TESTS (2D ENGINE) (Sheet 11 of 11)

19.

Using 7/16 inch wrench if required, close bleed cap (R) until snug by turning clockwise.

20.

Using adjustable wrench, remove pipe plug from upper sensor hole (A).

21.

Using 1/2 inch wrench, install sensor retaining nut (S).

NOTE

Upper sensor (E) is longer than lower sensor (F).

22.

Using 1/2 inch wrench to hold sensor retaining nut

(S), use 9/16 inch wrench and install upper sensor

(E) into fuel-water separator (D).

23.

Using adjustable wrench, remove pipe plug from

lower sensor hole (T).

24.

Using 1/2 inch wrench, install sensor retaining nut

(U).

25.

Using 1/2 inch wrench to hold sensor retaining nut

(U), use 9/16 inch wrench and install lower sensor

(F) into fuel-water separator (D).

26.

Position clamp (V) onto fuel-water separator and,

using 1/2 inch socket, install three capscrews, new

lockwashers, and flat washers (W).

27.

Using 1/2 inch socket, tighten capscrew (X).

28.

Install powerplant (page 5-40).

29.

Purge fuel system (page 7-10).

End of Task

TA148330

7-255