TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 519 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR OPERATIONAL TESTS (2D ENGINE) (Sheet 6 of 11)

15-SECOND DRAIN TEST:

1.

Using adjustable wrench, loosen pipe plug in upper sensor hole (A) enough to allow fuel to leak.

2.

Check to see if fuel leaks from upper sensor hole (A).

3.

If fuel does not leak from upper sensor hole (A), remove pipe plug from upper sensor hole (A) and go on to step 4.

If fuel does leak from upper sensor hole (A), use adjustable wrench to tighten pipe plug in upper sensor hole (A),

and go to step 8.

CAUTION

Be very careful not to disturb center

filter element.

Center filter element

must be replaced if disturbed in any

way.

4.

Using 7/16 inch wrench, remove eight screws,

lockwashers, and flat washers (B) securing cover

(C) to separator (D).

Remove cover (C) from

separator (D).

5.

Add fuel to fuel-water separator (D) until fuel leaks

from upper sensor hole (A).

6.

Using adjustable wrench, install pipe plug into

upper sensor hole (A).

7.

Place cover (C) in position and, using 7/16 inch

wrench, install eight screws, lockwashers, and flat

washers (B).

Go on to Sheet 7

TA148325

7-250