TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

  TM-9-2350-260-20-1-2 - Page 523 of 772

TM 9-2350-260-20-1-2
FUEL-WATER SEPARATOR OPERATIONAL TESTS (2D ENGINE) (Sheet 10 of 11)
11.
Remove tip of lower (F) sensor probe from water in metal container (G) before 15 seconds have gone by from time
of putting it in and check if fluid stops draining from solenoid drain valve drain tube (J).
12.
If fluid does not start draining (step 9), does not
keep draining (step 10), or does not stop draining
(step 11), refer to troubleshooting procedures
(page 4-256).
13.
Disconnect cable (Figure F-7, Appendix F) from
both terminals of power source (K).
14.
Disconnect connector (L) at fuel-water separator
control box (M).
15.
Disconnect cable (N) (Figure F-8, Appendix F)
from power source (K).
16.
Disconnect cable (N) (Figure F-8, Appendix F)
from metal container (G).
17.
Remove metal container (P) from under solenoid
drain valve drain tube (J).
18.
Using pliers, connect engine electrical harness
connector (Q) to fuel-water separator control box
(M) by turning clockwise.
Go on to Sheet 11
TA148329
7-254


Back to Top