TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 521 of 772

TM 9-2350-260-20-1-2

FUEL-WATER SEPARATOR OPERATIONAL TESTS (2D ENGINE) (Sheet 8 of 11)

SEQUENTIAL DRAIN TEST:

1.

Using adjustable wrench, loosen pipe plug in upper sensor hole (A) enough to allow fuel to leak.

2.

Check to see if fuel leaks from upper sensor hole (A).

3.

If fuel does not leak from upper sensor hole (A), remove pipe plug from upper sensor hole (A) and go on to step 4.

If fuel does leak from upper sensor hole (A), use adjustable wrench to tighten pipe plug in upper sensor hole (A)

and go to step 8.

CAUTION

Be very careful not to disturb center

filter element.

Center filter element

must be replaced if disturbed in any

way.

4.

Using 7/16 inch wrench, remove eight screws,

lockwashers, and flat washers (B) securing cover

(C) to separator (D).

Remove cover (C) from

separator (D).

Throw lockwashers and gasket

away.

5.

Add fuel to fuel-water separator (D) until fluid level

is above upper sensor hole (A).

6.

Using adjustable wrench, install pipe plug into

upper sensor hole (A).

7.

Place cover and new gasket (C) in position and,

using 7/16 inch wrench, install eight screws, new

lockwashers, and flat washers (B).

Go on to Sheet 9

TA148327

7-252