TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

  TM-9-2350-260-20-1-2 - Page 661 of 772

TM 9-2350-260-20-1-2
ACCELERATOR PEDAL REPLACEMENT (Sheet 2 of 4)
NOTE
Tag shims which may be located under housings (L) and (M) for installation.
9.
Using hammer and punch, remove woodruff key (N) from control rod (C).
10.
Remove housing (L) from control rod (C).
Using hammer and punch, remove two bearings (L) if bearings are
damaged or worn.
11.
Using 7/16 inch wrench, remove two screws and lockwashers (Q) securing pedal (P) to control rod (C).
12.
Slide accelerator pedal (P) in direction of arrow to allow access to two woodruff keys (R).
13.
Using hammer and punch, remove two woodruff keys (R).
14.
Slide accelerator pedal (P) off control rod C).
15.
Using 9/16 inch wrench, remove screw (S) and nut (T) from accelerator pedal (P).
Retain screw and nut for
installation onto replacement accelerator pedal.
Go on to Sheet 3
TA148467
7-392


Back to Top