TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 669 of 772
TM 9-2350-260-20-1-2
ACCELERATOR LEVER ASSEMBLY REPLACEMENT (Sheet 2 of 3)
7.
Remove washer bearing (N) from support (M).
8.
Using socket, remove two screws (P), lockwashers (Q), and cable clamp (R).
Throw lockwashers away.
9.
Remove support (M) from tank.
10.
Inspect bearing in lever (L).
If bearing is defective, use hammer and drive pin punch and drive bearing out of lever
(L).
CLEANING AND INSPECTION:
1.
Clean all parts using dry cleaning solvent (Item 54, Appendix D), and clean rags (Item 65, Appendix D).
2.
Inspect al parts for cracks, bends, wear, and other defects.
INSTALLATION:
1.
Line up holes in bracket (A), clamp (B), and
support (C).
2.
Using fingers, install two screws (D) and new
lockwashers (E) in bracket (A), clamp (B), and
support (C).
3.
Install washer bearing (F) on support (C).
Go on to Sheet 3
TA148507
7-400
Back to Top
