TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

  TM-9-2350-260-20-1-2 - Page 684 of 772

TM 9-2350-260-20-1-2
ACCELERATOR FLANGE ASSEMBLY REPAIR (Sheet 2 of 2)
CLEANING AND INSPECTION:
1.
Using clean rags and dry cleaning solvent, (Item
54, Appendix D) clean flange (A), bushing (B), and
fitting (C) thoroughly.
2.
Check bushing (B), flange (A) and fitting (C) for
damage or wear.
Replace If required.
ASSEMBLY:
1.
Position new bushing (A) in end of flange (B).
2.
Place flange (B) and bushing (A) in vise.
3.
Tighten vise against bushing (A) and flange (B)
until bushing (A) is fully inserted in flange (B).
4.
Remove flange (B) from vise.
5.
Using fingers, press new seals (C) into ends of
flange (B).
6.
Using wrench, install fitting D) on flange (B).
7.
Install flange assembly (page 7-412).
End of Task
TA148521
7-415


Back to Top