TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 681 of 772

TM 9-2350-260-20-1-2

ACCELERATOR FLANGE ASSEMBLY REPLACEMENT (Sheet 3 of 4)

7.

Using 9/16 inch wrench, remove two nuts (G) and

lockwashers (H) from flange assembly (J) and

mounting stud (K).

Throw lockwashers away.

8.

Slide flange assembly (J) off end of rod assembly.

INSTALLATION:

1.

Using fingers, slide flange assembly (A) over rod

assembly (B) onto mounting studs (C).

2.

Using 9/16 inch wrench, install two new

lockwashers (D) and nut (E) o mounting studs (C).

3.

Using fingers, turn nut (1) o rod assembly (B).

4.

Using 7/16 inch wrench, install rod end (G) on rod

assembly (B).

Turn rod end (G) until holes in rod

end (G) and rod assembly (B) are alined.

5.

Using 1/2 inch wrench, tighten nut (F) on rod

assembly (B) against rod end (G).

Go on to Sheet 4

TA148518

7-412