TM 9-2350-260-20-1-2
BULKHEAD PLATE ASSEMBLY REPLACEMENT (Sheet 3 of 6)
12.
Using 9/16 inch socket, remove six screws and
lockwashers (M).
Throw lockwashers away.
13.
Remove plate assembly (L) and gasket (N) from
bulkhead (P).
14.
Slide plate assembly () and gasket (N) off brake
rod (H), tachometer cable (A), and accelerator rod
(Q).
Throw gasket (N) away.
CLEANING AND INSPECTION:
1.
Using dry cleaning solvent (Item 54, Appendix D), clean plate assembly.
2.
Inspect seals in each end for nicks, tears, or cuts.
If damaged, replace.
3.
Inspect bushing inside sleeve for wear, loose, missing or defective bearings.
If defective, replace.
4.
Inspect lubrication fitting.
If damaged, replace.
Go on to Sheet 4
TA148524
7-418