TM-9-2350-260-20-1-2
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9
TM-9-2350-260-20-1-2 - Page 697 of 772
TM 9-2350-260-20-1-2
EXHAUST PIPE (LEFT SIDE) REPLACEMENT (Sheet 3 of 4)
INSTALLATION:
1.
Position packing (A) and clamp (B) onto pipe (C) and, using flat-tip screwdriver, tighten screw on clamp (B),
securing packing to pipe (C).
2.
Check insulation halves (D) and all attaching hardware for damage.
Replace if necessary.
3.
Position insulation halves (D) onto exhaust pipe
(C).
4.
Using wrench and cross-tip screwdriver, install 14 screws (E), each with two flat washers (F), one new lockwasher
(G), and one nut (H) to hold insulation halves (D) to exhaust pipe (C).
5.
Position new gasket (J) onto turbosupercharger housing (K).
6.
Slide exhaust pipe extension (L) into tube (M) as
far as it will go.
7.
Position exhaust pipe (C) with installed insulation
halves (D) onto turbosupercharger housing (K).
Make sure exhaust port (N) is pointing up.
Go on to Sheet 4
TA146423
8-7
Back to Top
