TM-9-2350-260-20-1-2

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 2 OF 4, CHAPTERS 5 THRU 9

TM-9-2350-260-20-1-2 - Page 701 of 772

TM 9-2350-280-20-1-2

EXHAUST PIPE (RIGHT SIDE) REPLACEMENT (Sheet 3 of 4)

INSTALLATION:

1.

Position packing (A) and clamp (E) onto pipe (C) and, using flat-tip screwdriver, tighten screw on clamp (B) securing

packing to pipe (C).

2.

Check insulation halves (D) and all attaching hardware for damage.

Replace if necessary.

3.

Position insulation halves (D) onto exhaust pipe

(C).

4.

Using 5/16 inch wrench and cross-tip screwdriver, install 14 screws (E), each with two flat washers (F), one new

lockwasher (G), and one nut (H) to hold insulation halves D) to exhaust pipe (C).

5.

Position new gasket (J) onto turbosupercharger

housing (K).

6.

Position exhaust pipe (C) with installed insulation

halves (D) onto turbosupercharger housing (K).

Make sure exhaust port (L) is pointing up.

7.

Using 9/16 inch socket and 7/8 inch wrench, install

six new self-locking nut (M) securing exhaust pipe

to housing.

Go on to Sheet 4

TA146427

8-11