TM 9-2350-260-20-1-3
MASTER CONTROL PANEL REPAIR (Sheet 68 of 71)
Master Control Panel Personnel Heater Wiring Harness Replacement (Sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
10-130
Installation
10-132
TOOLS:
Flat-tip screwdriver
Long round nose pliers
Ratchet with 1/2 in. drive
3/4 in. socket with 1/2 in. drive
11/32 in. combination box and open end wrench
Cross-tip screwdriver
SUPPLIES:
Silicone compound tem 32, Appendix D)
Lockwasher (MS35338-42)(4 required)
Lockwasher (MS35338-43)(6 required)
PRELIMINARY PROCEDURE:
Remove panel from tank (page 10-54)
REMOVAL:
1.
Using screwdriver on screw (A) and 11/32 inch wrench on nut (B), remove four screws (A), lockwashers (C) and nuts
(B) securing connector (D) to panel.
Throw lockwashers away.
2.
Remove connector (D) from panel and position aside.
3.
Using fingers, remove electrical connector (circuit 400) from rear of switch (E).
Go on to Sheet 2
TA147162
10-130