TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 333 of 783

TM 9-2350-260-20-1-3

ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR

Male Plug Repair (Sheet 2 of 3)

9.

Push new contact (E) into hole back of plug

assembly (B) far enough so it will remain standing.

10. Push jumper wire end, first through grommet

retaining nut (A) and then through hole in grommet

(D).

7.

Using hand wire stripper, strip insulation from jumper

wire equal to depth of contact solder well (F).

8.

Placing connector face down on flat surface, apply a

small amount of silicone (Item 32, Appendix D) to

empty holes on back of plug assembly (B) and on

front of grommet (D).

11. Hold jumper wire so wire end is pushing down onto

solder in contact solder well (F).

12. Hold soldering gun tip against side of contact (E)

until solder begins to melt and wire slips into contact

solder well (F).

13. Removing soldering gun from side of contact (E),

continue holding wire until solder has cooled and

set.

Go on to Sheet 3

TA147353

10-321