TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 335 of 783

TM 9-2350-260-20-1-3

ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR

Male Connector Repair (Sheet 1 of 1)

TOOLS: Electrical connector repair tool kit

Diagonal cutting pliers

Multimeter

PRELIMINARY PROCEDURE:

Disconnect three battery straps (page 10-294)

1.

Slide shell (A) back along cable (B).

3.

Using hand wire stripper, strip insulation from cable

(B) equal to well depth in terminal (C).

4.

Insert stripped cable end (E) into well in terminal (C).

2.

Using diagonal cutting pliers, cut terminal (C) and C-

washer (D) from cable (B).

Throw terminal (C) and

C-washer (D) away.

5.

Using crimping tool, crimp terminal (C).

6.

Push new C-washer (D) onto cable (B) at rear of

terminal.

7.

Slide shell (A) forward along cable (B) until tight against C-washer (D).

8.

Using multimeter, check continuity of repaired circuit.

9.

Connect three battery ground straps (page 10-294).

End of Task

TA147355

10-323