TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 344 of 783

TM 9-2350-260-20-1-3

ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR

Female Connector With Washer (12 Gage Cable) Repair (Sheet 1 of 1)

TOOLS: Electrical connector repair tool kit

Diagonal cutting pliers

Multimeter

PRELIMINARY PROCEDURES: Disconnect three battery ground straps (page 10-294)

Loosen or remove cable clamps as required

1.

Slide shell (A) back along cable (B).

3.

Using hand wire stripper, strip insulation from cable

(B) equal to well depth in terminal (C).

4.

Slide new washer (D) onto stripped cable end (E)

back to cable insulation.

2.

Using diagonal cutting pliers, cut terminal (C) and

washer (D) from cable (B).

Throw terminal (C) and

washer (B) away.

5.

Insert stripped cable end (E) into well in terminal (C).

6.

Using crimping tool, crimp terminal (C).

7.

Slide shell (A) forward until tight against washer (D).

8.

Using multimeter, check continuity of repaired circuit.

9.

Tighten or install cable clamps as required.

10. Connect three battery ground straps (page 10-294).

End of Task

TA147364

10-332