TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 345 of 783

TM 9-2350-260-20-1-3

ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR

Female Connector With Sleeve (14 and 16 Gage Cable) Repair (Sheet 1 of 1)

TOOLS: Electrical connector repair tool kit

Diagonal cutting pliers

Multimeter

PRELIMINARY PROCEDURES:

Disconnect three battery ground straps (page 10-294)

Loosen or remove cable clamps as required

1.

Slide shell (A) and sleeve (B) back along cable (C).

3.

Using hand wire stripper, strip insulation from cable

(C) equal to well depth in terminal (D).

4.

Insert stripped cable end (E) into well in terminal (D).

2.

Using diagonal cutting pliers, cut terminal (D) from

cable (C).

Throw terminal (D) away.

5.

Using crimping tool, crimp terminal (D).

6.

Slide sleeve (B) forward along cable (C) until tight

against terminal (D).

7.

Slide shell (A) forward along cable (C) until tight against sleeve (B).

8.

Using multimeter, check continuity of repair circuit.

9.

Tighten or install cable clamps as required.

10. Connect three battery ground traps (page 10-294).

End of Task

TA147365

10-333