TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 343 of 783

TM 9-2350-260-20-1-3

ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR

Female Plug Repair (Sheet 3 of 3)

14. Using remover, push contact (E) into plug assembly

(B).

11. Hold jumper wire so wire end is pushing down onto

solder in contact solder well (F).

12. Hold soldering gun tip against side of contact (E)

until solder begins to melt and wire slips into contact

solder well (F).

13. Removing soldering gun from side of contact (E),

continue holding wire until solder has cooled and

set.

15. Sliding grommet (D) forward along cable (C), set

grommet (D) firmly against contacts (E).

16. Manually thread grommet retaining nut (A) onto plug

assembly (B).

17. Using multimeter, check continuity of repaired circuit.

18. Tighten or install cable clamps as required.

19. Connect connectors at each end of affected cable.

20. Connect three battery ground straps (page 10-294).

End of Task

TA147363

10-331