TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 342 of 783

TM 9-2350-260-20-1-3

ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR

Female Plug Repair (Sheet 2 of 3)

5.

Using diagonal cutting pliers, cut wire from contact

(E).

Throw away contact (E).

6.

Pulling cut wire out of grommet (D), use diagonal

cutting pliers to shorten wire about 6 inches.

Fasten

new end of cut wire to cable (C) with electricians

tape.

9.

Push new contact (E) into hole in back of plug

assembly (B) far enough so it will remain standing.

10. Push jumper wire end through grommet retaining nut

(A) and then through hole in grommet (D).

7.

Using hand wire stripper, strip insulation from jumper

wire equal to depth of contact solder well (F).

8.

Placing connector face down on flat surface, apply a

small amount of silicone (Item 32, Appendix D) to

empty holes on back of plug assembly (B) and on

front of grommet (D).

Go on to Sheet 3

TA147362

10-330