TM 9-2350-260-20-1-3
TRACK ASSEMBLY REPLACEMENT (Sheet 3 of 10)
7.
Keep on tightening puller screws until end connector
(C) is 1 inch out of track pins.
8.
Repeat steps 5 thru 7 at opposite side of track.
10. Using tool handle (F), tighten up on both fixtures (D)
until pins are squeezed together by clamps (E).
9.
Install track connecting fixtures (D) on both sides of
track so that clamps (E) fit around two pins of track.
11. Using 1-1/2 in.
socket again, go back to tightening
puller screws on both sides to remove both end
connectors (C) .
12. Remove pullers from end connectors.
Go on to Sheet 4
TA147884
14-83