TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 796 of 1008

TM 9-2350-261-20-2

ADJUST BRAKE LOCKING PAWL — Continued

0388 00

2.

Disconnect two return springs (2) from bracket (3).

3.

Remove two cotter pins (4) and two clevis pins (5) from two clevises (6) and differential brake levers (7). Discard

cotter pins.

4.

Remove two screws (8), locknuts (9), two quadrants (10), and stops (11) from bracket (12). Discard locknuts.

5.

Place quadrants (10) and stops (11) on bracket (12). Install screws (8) and new locknuts (9); push down on quadrants

while screws and locknuts are tightened.

6.

Check gap between pawls (1) and top of quadrants (2) while moving steering levers (3) from front to back. Use 5/32,

3/16. and 7/32 inch (4, 5, and 6 mm) diameter drill bit shanks to check gap. Clearance should be between 5/32 (4 mm)

and7/32(6mm)

.If5/32or3/16inch(4and5mm)drillswillfitbut7/32inch(6mm)drillwillnot

,gapisright

.If7/32

inch (6 mm) drill will fit, it must be snug in gap throughout lever travel for gap to be right.

0388 00-2