TM-9-2350-261-20-2
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4
TM-9-2350-261-20-2 - Page 82 of 1008
TM 9-2350-261-20-2
REPLACE FAN DRIVE ADJUSTABLE IDLER AND PULLEY — Continued
0213 00
5.
Remove nut (10) and spring (11) from adjusting sleeve (12).
6.
Remove decal (13) from adjusting sleeve (12) only if replacement is required.
7.
Remove cotter pin (14), straight pin (15), and arm (5) from transfer gearcase. Discard cotter pin.
8.
Remove two cotter pins (16), straight pin (17), and sleeve (12) from transfer gearcase. Discard cotter pins.
9.
Remove two retaining rings (18), bearings (19), and spacer (20) from pulley (4).
INSTALLATION
1.
Install two bearings (1) and spacer (2) in pulley (3). Secure with two retaining rings (4). Use snap ring pliers.
2.
Install new decal (5) (WP 0511 00) on adjusting sleeve (6) if required.
3.
Secure sleeve (6) to transfer gearcase with straight pin (7) and two new cotter pins (8).
4.
Secure idler pulley arm (9) to transfer gearcase with straight pin (10) and new cotter pin (11).
5.
Install nut (12) on rod end (13).
6.
Install adjusting nut (14) and spring (15) on sleeve (6).
7.
Install rod end (13) in nut (14).
8.
Secure rod end (13) to idler pulley arm (9) with pin (16) and new cotter pin (17).
0213 00-2
Back to Top
