TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 829 of 1008

TM 9-2350-261-20-2

REPLACE UPPER ACCELERATOR PEDAL ASSEMBLY — Continued

0396 00

INSTALLATION

1.

Install guide (1) on power plant compartment. Secure with four screws (2).

2.

Install two ball bearings (3) and springs (4) in pedal detent block (5). Secure with two set screws (6).

3.

Install two nuts (7) on two set screws (6).

4.

Install plunger (8) and spring (9) in pedal detent block (5).

5.

Install pedal detent block (5) on pedal (10). Secure with two screws (11) and locknuts (12).

6.

Use spring scale to adjust detent plunger (WP 0401 00). Use pressure to 35-40 pounds (16-18 kg).

7.

Install pedal assembly (10) in guide (1).

8.

Place bellcrank (13) and woodruff key (14) on pedal assembly (10) shaft. Tighten nut (15).

9.

Install link (16) on bellcrank (13). Secure with screw (17) and new locknut (18).

10. Connect return spring (19) to bellcrank (13).

FOLLOW-THROUGH STEPS

1.

Install lower accelerator pedal (WP 0395 00).

2.

Install driver’s power plant access panel (WP 0430 00).

3.

Install driver’s seat (WP 0478 00).

4.

Close power plant front access door and raise trim vane (see your -10).

5.

Raise and lock ramp (see your -10).

6.

Start engine (see your -10)

7.

Check that upper accelerator pedal operates properly.

8.

Stop/shutdown engine.

END OF TASK

0396 00-3/4 blank