TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 838 of 1008

TM 9-2350-261-20-2

REPAIR TRANSMISSION AND LOWER ACCELERATOR LINKAGE — Continued

0398 00

INSPECTION-ACCEPTANCE AND REJECTION CRITERIA

1.

Check links, shafts, and brackets for wear and damage. Replace if needed.

ASSEMBLY

NOTE

Lubricate connecting link rod-end bearings before installations. Use GAA grease.

1.

Install transmission cross-shaft (1) in transmission cross-shaft bracket (2).

2.

Install accelerator cross-shaft (3) in transmission cross-shaft (1).

3.

Install woodruff key (4) in accelerator cross-shaft (3).

4.

Install bellcrank (5) on accelerator cross-shaft (3). Secure with screw (6) and new locknut (7).

5.

Install transmission shifting link (8) on transmission cross-shaft (1). Secure with screw (9) and new locknut (10).

6.

Install throttle valve link (11) on bellcrank (5). Secure with screw (12) and new locknut(13).

NOTE

If any links were replaced or link ends turned, then adjust linkage (WP 0401 00).

7.

Install throttle link (14) on bellcrank (5). Secure with screw (15) and new locknut (16).

FOLLOW-THROUGH STEPS

1.

Install transmission and lower accelerator linkage (WP 0323 00).

END OF TASK

0398 00-2