TM-9-2350-261-20-3
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4
TM-9-2350-261-20-3 - Page 41 of 932
TM 9-2350-261-20-3
REPLACE POWER PLANT DOOR COMBAT LOCK
0426 00
THIS WORK PACKAGE COVERS:
Removal (page 0426 00-1).
Installation (page 0426 00-2).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0780 00, Item 29)
Materials/Parts
Drive pin
Locknut (16)
Personnel Required
Unit Mechanic
Helper (H)
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Trim vane lowered and disconnected (see your -10)
Power plant door open (see your -10)
Battery ground lead disconnected (WP 0294 00)
REMOVAL
NOTE
Tagormarkeachharnesstomakesureeachisinstalledintheproperconnector after service.
1.
Disconnect four wiring harnesses (1) from bulkhead connectors (2) inside driver’s compartment.
2.
Remove 16 locknuts (3) and screws (4), and four wiring harness connectors (2) from bulkhead. Discard locknuts.
3.
(H): Hold hand under bolt (5) from inside carrier through power plant access door opening.
4.
Drive out pin (6). Remove handle (7) and spring (8) from bolt (5). Discard drive pin.
5.
(H): Remove bolt (5) from power plant compartment.
042600-1
Back to Top
