TM-9-2350-261-20-3

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4

TM-9-2350-261-20-3 - Page 524 of 932

TM 9-2350-261-20-3

REPLACE RAMP LINKAGE (M113A2, M901A1, AND M1059 ONLY) — Continued

0558 00

INSTALLATION

1.

Place catch (17) on ramp. Secure with new square washer (16) and screw (15). TIGHTEN SCREW TO 60-70 LB-FT

(81-95 N·M) TORQUE. Use torque wrench. Bend corner of square washer to lock screw.

2.

For hex shaped rod (9), install nut (13), new key washer (12), and clevis (14) on right-hand threaded end of rod (9). Do

not bend tabs on key washer until lock adjustment (Step 9).

3.

Install flat shaped rod (8) or hex shaped rod (9) in welded brackets. As rod passes through each bracket, install three

bumpers (10) on flat shaped rod (8), or three bushings (11) on hex shaped rod (9).

4.

Place bracket (7) on hull top plate. Install two washers (6) and screws (5). Do not tighten screws until lock adjustment

(Step 9).

5.

Align flat shaped rod (8) or hex shaped rod (9) and latch (4) in bracket (7). Secure with four washers (2), headed pin

(3), and new cotter pin (1).

0558 00-4