TM-9-2350-261-20-3

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4

TM-9-2350-261-20-3 - Page 523 of 932

TM 9-2350-261-20-3

REPLACE RAMP LINKAGE (M113A2, M901A1, AND M1059 ONLY) — Continued

0558 00

4.

Remove cotter pin (1), four washers (2), headed pin (3), and latch (4). Discard cotter pin.

5.

Remove two screws (5), washers (6), and bracket (7) from hull top plate.

6.

Pull flat shaped rod (8) or hex shaped rod (9) from welded brackets on hull top plate. Remove three bumpers (10) as flat

shaped rod is removed, or three bushings (11) as hex shaped rod is removed.

7.

For hex shaped rod (9), bend back tabs on key washer (12), loosen jamnut (13), and remove clevis (14) from rod (9).

Remove jamnut (13) from rod (9) and discard key washer.

8.

Bend back tab corner and remove screw (15), square washer (16), and catch (17) from ramp. Discard square washer.

055800-3