TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 228 of 508

TM 9--2520--215--34

0044 00--8

OUTPUT REDUCTION GEAR PLANETARY CARRIER ASSEMBLY REPAIR –

CONTINUED

0044 00

ASSEMBLY – Continued

NOTE

Except where both a new carrier and a new lockpin are used, stake lockpin holes by center

punching. This will ensure that lockpin does not work out during operation.

9. Perform Steps 2 through 8 to install three remaining spindles, pinions, six lockwashers and 78 rollers.

WARNING

Use gloves and tongs when handling hot bearings to prevent injury.

10. Heat roller bearing (1) to approximately 300 degrees F. Install roller bearing (1) onto output reduction gear

planetary carrier assembly (2). Tap inner race to seat roller bearing (1) firmly against output reduction gear

planetary carrier assembly (2).

NOTE

FOLLOW--ON MAINTENANCE:

Install brake apply cam assembly

(WP 0041 00)

END OF WORK PACKAGE