TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 220 of 508

TM 9--2520--215--34

0043 00--6

OUTPUT REDUCTION GEAR PLANETARY CARRIER ASSEMBLY AND

BRAKE HOUSING ASSEMBLY REPLACEMENT – CONTINUED

0043 00

INSTALLATION – Continued

NOTE

There are two scribe marks 180 degrees apart. Either may align with lifting hole.

7. Use improvised sling as shown to install brake housing assembly (5) onto ring gear (14), aligning scribe mark (15)

with lifting hole (16).

8. Use lifting sling, 3/4--16 eye--bolt and a suitable lifting device to lift assembly from improvised stand. Lower

assembly to floor or table and, with lifting device still attached, install 20 bolts (4).

NOTE

FOLLOW--ON MAINTENANCE:

Install brake hub assembly (WP 0050 00)

END OF WORK PACKAGE