TM-9-2520-234-35

POWER TRAIN ASSEMBLY; ALLISON MODEL XTG411-2A

TECHNICAL MANUAL; FIELD AND DEPOT MAINTENANCE MANUAL

JULY 1962

TM-9-2520-234-35 - Page 163 of 323

PAR

15 3

REAR HOUSING REBUIL D

CHAP

5,

SEC

XVII I

Figure 178. Removing right-cam follower link

assembly shaft

Figure 179. Removing (or installing) left-cam

follower and brake apply link assembly

q . Remove pin 9, bearing 12 and brake

apply link 11 from cam follower link 3.

r . Remove the left-brake apply cam ro-

tating ring 19 (fig. 378, fold-out 7) and 12

balls 27. Remove ring seal 26 and expander

25 from cam ring 19 only if replacement is

necessary .

s . Remove set screw (fig. 179).

Figure 180.

Removing

(or installing) right-cam

follower and brake apply link assembly

Figure 181. Removing brake apply shaft retainer

and gasket

t . Remove the right-cam follower an d

brake apply link assembly (fig. 180).

u . Remove retaining ring 67 (fig. 379,

fold-out 8) that retains pin 59 in right-cam

follower link 60.

v . Remove pin 59, cam follower 62, bear-

ing rollers 63 and washers 61 and 64 from

cam follower link 60.

w . Remove retaining ring 68 that retains

brake apply link pin 58.

x . Remove pin 58, bearing 70 and brake

apply link 71 from cam follower link 60.

y.

Remove

right-brake

apply

rotating

cam ring 13 (fig. 380, fold-out 9) and 12 balls

13 1