TM-9-2520-234-35

POWER TRAIN ASSEMBLY; ALLISON MODEL XTG411-2A

TECHNICAL MANUAL; FIELD AND DEPOT MAINTENANCE MANUAL

JULY 1962

TM-9-2520-234-35 - Page 199 of 323

PAR

227,

STEPS

15-1 8

ASSEMBL Y

CHAP

5,

SEC

XXXII I

Figure 254 (Step 15)

Install the intermediate-range carrier an d

low-range ring gear assembly (A). This as-

sembly will have to engage all high-range

clutch plates and intermediate-range ring gear

while being installed.

Assembly is properl y

installed when external splines of the assembly

touch, or nearly touch, the intermediate-range

piston.

Figure 255 (Step 16)

Remove intermediate-range piston housin g

3/8-16 x 1-3/4 bolt (A), lock washer (B) and

flat washer (C). Install low-range clutc h

anchor (D). Using a pry bar (E), depres s

anchor (D) and install bolt (A), washer (B)

and washer (C). Tighten the bolt (A) and then

loosen slightly.

Note . Place a piece of soft

metal between the end of bar (E) and the con-

tact surface of anchor (D).

Figure 256 (Step 17)

Install low-range clutch anchor bolt (A), wash-

er (B) and 5/8-18 nut (C). Tighten nut only

finger-tight at this time.

Figure 257 (Step 18)

Install four internal- (A) and four external-

splined (J) low-range clutch plates alternately,

beginning with an internal-splined plate (A).

16 7