TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 218 of 933

1. POSITION NEW GASKET (1) AND PTO

ACCESS COVER (2) ON POWER

TAKEOFF MOUNT (3).

a. Install three lock washers (4),

screws (5), washers (6), and nuts (7)

in top three holes of mount (3).

2

3.

4.

INSTALL COVER (2),

a. Install seven lock washers (8) and

screws (9).

USING 1/2-lNCH DRIVE TORQUE

WRENCH, TORQUE THREE SCREWS (5)

AND NUTS (7) TO 30-35 ft-lb (4-5 mkg).

USING 1/2-lNCH VE TORQU E

WRENCH, TORQUE SEVEN SCREWS (9)

TO 30-35 ft-lb (4-5 mkg).

5. INSTALL TWO PROTECTIVE CAP

PLUGS (10).

a. Install one plug (10) on splined

shafts (11) on each side of

transmission.

2-154

Change 1

TM 9-2520-270-34

REMOVE TRANSMISSION FROM TIP-OVER STAND AND TIP-OVER

STAND FIXTURE