TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 346 of 933

TM 9-2520-270-34

11. DELETED.

12. REMOVE CROSS SHAFT ASSEMBLY.

13.

14.

See task REPLACE CROSS SHAFT

ASSEMBLY, page 4-458.

REMOVE HYDRAULIC ACCUMULATOR.

See task REPLACE HYDRAULIC

ACCUMULATOR, page 4-448.

REMOVE SECOND RANGE BRAKE

ASSEMBLIES. See task REPLACE

SECOND RANGE BRAKE ASSEMBLIES,

page 4-432.

18. USING 1/8-lNCH DRIVE PIN PUNCH (1)

(ITEM 26), DRIVE GROOVED PIN (2)

OUT OF HOUSING (3) UNTIL PUNCH

SHOULDER (4) CONTACTS HOUSING.

REMOVE PUNCH FROM HOUSING.

15. REMOVE RIGHT-HAND HYDRAULIC

ASSEMBLY. See task REPLACE RIGHT-

HAND HYDRAULIC ASSEMBLY,

page 4-378.

16. REMOVE LEFT-HAND HYDRAULIC

ASSEMBLY. See task REPLACE

LEFT-HAND HYDRAULIC ASSEMBLY,

page 4-360.

17. REMOVE INPUT BEVEL ASSEMBLY. See

task REPLACE INPUT BEVEL

ASSEMBLY, page 4-94.

18.1. REMOVE GROOVE PIN (2).

a. Insert 0.141-inch tapered pin (5)

and punch (1) (Item 26)

into hole (6) in housing (3).

b. Drive punch (1) until grooved

pin (2) is free of housing (3).

c. Remove tapered pin (5) and

punch (1).

d. Discard grooved pin (2).

Change 3

4-4 6