TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 348 of 933

TM 9-2520-270-34

22. INSPECT ROLLER BEARINGS (1)

AND (2).

a. Inspect bearings (1) and (2) for

damage. See TM 9-214.

b. If either bearing (1) or (2) is

damaged, go to step 23. If bearings

are not damaged, go to step 26.

24. REMOVE INTERNAL SNAP RING (4).

a. Turn gear (3) over.

b. Using screwdriver, pry out internal

snap ring (4).

Change 1

23. REMOVE AND DISCARD BEARING (1).

a. Place gear (3) on two wood blocks.

Do not place blocks in way of

bearing (1).

b. Using 1/8-inch drive pin punch

(Item 26) and hammer, remove and

discard bearing (1).

I

25. REMOVE AND DISCARD BEARING (2).

a. Using 1/8-inch drive pin punch

(Item 26) and hammer, remove and

discard bearing (2).

b. Replace gear (3) if damaged.

4-48