TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 350 of 933

TM 9-2520-270-34

29. INSTALL GEAR (1) AND TWO

THRUST WASHERS (2).

a. Aline thrust washer (2), gear (1),

and second thrust washer (2) with

hole in main housing (3).

31. INSTALL NEW GROOVED PIN (7).

a. Drive in new pin (7) until end is 0.02

to 0.05 inch (0.5- 1.3 mm)

below edge

of hole (8).

32. USING DRIVE PIN PUNCH (9)

(ITEM 25), STAKE HOLE (8).

4-50

Change

1

30. INSTALL SPINDLE (4).

a. Aline mark (5) on spindle (4) with

mark (6) on main housing (3).

b. Using plastic-faced hammer, tap

spindle (4) through main housing (3),

two thrust washers (2), and

gear (1),