TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 359 of 933

STEPS 29 THROUGH 31 DELETED.

WARNING

Solvent fumes can burn and

could poison you. Read warn-

ing In the front of this

manual.

32. CLEAN MOUNTING SURFACES (5)

AND (6).

a. Use wiping rag dampened with

cleaning solvent.

CAUTION

Do not allow lip of seal to catch on shaft. Seal

may leak causing damage to equipment.

33. POSITION NEW GASKET (7) AND

COVER (2).

a. Apply petrolatum to gasket mounting

surface (5).

b. Aline new gasket (7) with pins (8),

and position on mounting surface (5).

c. Aline cover (2) with pins (8), and

position on mounting surface (5).

34. SECURE COVER (1).

a. Place ring (2), flat side out, on

cover (1).

b. Aline ring (2) with bolt holes and

pins (3).

c. Install 12 new lock washers (4) and

bolts (5).

35. USING 3/8-lNCH DRIVE TORQUE

WRENCH AND 7/16-lNCH SOCKET,

TORQUE 12 BOLTS (5) TO

75-85 in-lb (86-98 cmkg).

END OF TASK

Change 3

4-59 (4-60 blank)

TM 9-2520-270-34