TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 358 of 933

TM 9-2520-270-34

CAUTION

Do not lower transmission below horizontal

position. Parts may fall out and be damaged.

25. SLOWLY LOWER TRANSMISSION (1)

TO HORIZONTAL POSITION.

27. INSTALL PLATE ASSEMBLy (4).

a. Install plate assembly (4) so that

pins and springs (3) are positioned

against tangs (5). Hold plate assembly

in place.

b. Alternately install 12 washers (6)

and screws (7).

NOTE

New springs must be used with new clutch

plates.

26. INSTALL 12 PINS (2) AND SPRINGS (3)

IN PLATE ASSEMBLY (4).

a. Firmly seat 12 pins (2) in plate

assembly (4).

b. Place spring (3) on each pin (2).

28. USING 1/2-INCH DRIVE TORQUE

WRENCH, TORQUE 12 SCREWS (7)

TO 28-30 ft-lb (4 mkg).

4-58

CAUTION

Do not allow springs to fall off plate assembly.

Damage to equipment can result.