TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 349 of 933

TM 9-2520-270-34

INSTALL

26. INSTALL NEW BEARINGS (1) AND (2).

a.

If bearings (1) and (2) were removed or

gear (3) was replaced, go to step 26b.

If two bearings were not removed or

gear was not replaced, go to step 27.

b. Install internal snap ring (4).

c. Using arbor press and bearing installer,

install new bearings (1) and (2) with

retaining rings (5) facing out.

27. MARK SPINDLE (6) AT POINT (7),

WHICH ALINES WITH CENTER OF PIN

GROOVE (8).

28. MARK MAIN HOUSING (9) AT

POINT (10), WHICH ALINES WITH

CENTER OF PIN GROOVE (11).

GO TO NEXT PAGE

4-49