TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 368 of 933

3. LOOSEN COVER ASSEMBLY (1).

a. Remove 10 screws (2) and lock

washers (3). Discard lock washers.

b. Pry under two tabs (4) a little at a

time until cover assembly (1) is loose.

6. INSPECT ELEMENT (5).

a. Pull element (5) straight up and out of

oil filter cavity (7).

b. Note if element (5) is

damaged.

7. DISCARD ELEMENT (5).

NOTE

Filter element may come out with cover

assembly.

4. REMOVE COVER ASSEMBLY (1).

a. Remove cover assembly (1). If oil

filter element (5) comes out with

cover assembly, separate element

from assembly.

5. REMOVE AND DISCARD OIL

FILTER GASKET (6).

8. CHECK FILTER CAVITY(7).

a.

b.

c.

Using fluid gun, remove remaining oil

from filter cavity ( 7 ).

Using measuring device, check

cavity ( 7 ) for metal chips and note

contamination.

If element was damaged or more than 1/4

tsp (1 cc) of chips are found, go to

step 8.1. If not, go to step 15.

8.1 INSPECT OIL FILTER COVER ASSEMBLY,

page 4-76.2.

STEPS 9 THROUGH 14 DELETED.

4-88

Change 3

TM 9-2520-270-34